B&G Deckman - Manual (Page 107)

Chapter 7: Instruments
7.2
Figure 7.1
After your initial installation, if you want to check or change
Communications settings, choose gmenu>configure comms.
WTP system
The instruments control functions in Deckman work in a similar way
to the h2000 and Ockam systems, despite the fact that there are some
essential differences in the way the WTP handles data. The WTP uses a
faster processor and more sophisticated calculations than other systems,
and you will therefore be able to use much lower damping values—
some typical ones are shown in Figure 7.2.