B&G Deckman - Manual (Page 106)

Configure comms
7.1
Chapter 7 : Instruments
Selecting gmenu>change instruments allows you to choose which type
of instrument system you wish to connect to. For each, there are a
number of options and settings that you may wish to adjust. The
following gives a brief description of the ways in which each instrument
system works in conjunction with Deckman. For further details on many
of the functions mentioned below, see the appropriate section in your
system's manual.
Once you have established a connection to a particular instrument
system and set up the communications, selecting gmenu> instruments
control allows you to set up the system: enter calibration values, specify
variables to be shown on the displays and so on. The following notes
provide information specific to each instrument system.
Configure comms
When you first connect to an instrument system you will be presented
with a Communications dialog like that shown in Figure 7.1. Set up the
protocol for your instrument system according to the table and then click
Next.
WTP Performance
Processor
h1000
Hydra
NMEA
Ockam
Baud 9600 9600 4800 4800
Parity NONE EVEN NONE NONE
Data 8 7 8 8
Stop 1 2 1 1