Display, Sources - ir, Netstreams ir receiver – ClearOne DigiLinX User Manual
Page 98: Ir block, Contact closures, Power, Specifications, Specifications -3
TheaterLinX
13-3
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Display
This section includes a power sense connection like those used on an MLA101 (used to
determine if the device is powered), a Pass-through for power sense, and and IR output
used to control the display.
Sources - IR
This section contains slots for connecting the IR emitter to the TH100; used to control
sources.
NetStreams IR Receiver
A connection for the NetStreams IR receiver. 3
rd
party IR recievers are not compatible,
use the IR block connection for 3
rd
party IR systems.
IR Block
If a third party IR distribution system is used, it would be connected here.
Contact Closures
Output relays can be set to normally open or closed, and triggered by a macro. Input
contact closures look for high/low and open/closed signals to trigger macros.
Power
Power connection for usage with any DigiLinX power supply.
Specifications
Audio Input Connectors
Analog RCA (1 pair)
Stereo S/PDIF
Control
IR (Reciever, Display, and Sources) 3.5mm to IR
RS-232 (Reciever Only)
3.5mm to DB9 (Female)
IR Block Connection (output)
3 pin modular connector
IR Block Connection (input)
3.5mm
Ethernet Connection
RJ45
Power Sense (Reciever & Display)
RCA
Contact Closures
1) Input
2 pin modular connector
3) Output
2 pin modular connector
IR Emitter
3 included
IR Receiver
1 included
Adhesive rubber feet
4 included