Introduction, Pre-wiring for ip audio, Requirements – ClearOne DigiLinX User Manual
Page 28: Cables, Terminating wires, Chapter 3, Pre-wiring for ip audio and ip video -1, Introduction -1, Pre-wiring for ip audio -1, Requirements -1
3-1
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 /
Chapter
3
Pre-Wiring for IP Audio and IP Video
Introduction
This chapter covers pre-wiring for a DigiLinX audio and video network. DigiLinX
architecture is similar to the architecture used in computer networking. You require
devices, a network connection, and power.
Pre-Wiring for IP Audio
Requirements
Cables
The following cables are required to pre-wire for DigiLinX IP audio:
NOTE:
When wiring for Ethernet, do not exceed 100 meter (328 foot) cable runs.
Siamese CAT5 16/4 (or CAT5 14/4) AWG cable
RG6 cable
CAT5e cable.
Terminating Wires
The following are required to terminate wires:
RJ45 crimpers
CAT5 stripper
wire cutters/strippers
small flat-head screw driver
RJ45 connectors
Phoenix connectors (for power and speaker connections). These are provided with
your NetStreams system.