Configuring an iport for digilinx, Wiring, Chapter 15: connecting third-party devices -1 – ClearOne DigiLinX User Manual
Page 108: Configuring an iport for digilinx -1, Wiring -1, Connecting third-party devices
15-1
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 /
Chapter
15
Connecting Third-Party Devices
Configuring an iPort for DigiLinX
This section shows you how to configure an iPort for a NetStreams DigiLinX system
using DigiLinX Dealer Setup.
Wiring
To wire an iPort into a DigiLinX system, see Figure 15-1.
Figure 15-1
Wiring an iPort
1.
Using an RJ45 connector, connect the iPort audio to the back of the iPort wall
plate.
This manual is related to the following products: