Connecting home theater audio, Requirements, How it works – ClearOne DigiLinX User Manual
Page 109: Connecting home theater audio -2, Requirements -2 how it works -2
DigiLinX Installation and Design Guide
15-2
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
2.
Using RCA cables, connect the left and right audio of the iPort wall plate to the left
and right in ports on the MediaLinX.
3.
Connect the RJ11 connector from the RS-232 port on the iPort wall plate.
4.
Connect the 3.5mm connector from the RS-232 port on the MediaLinX.
5.
Connect the male and female DB9 connectors on the loose ends of the cables in
steps 3 and 4.
NOTE:
Every manufacturer’s cable end is different. Therefore, you may need a gender
changer in step 5. However, do not use a null modem gender changer.
6.
Connect power to the iPort wall plate.
Connecting Home Theater Audio
This section explains how to integrate home theater audio with a NetStreams DigiLinX
system.
Requirements
speaker audio level switches as required
A/V receiver
sources
speakers
CAT5 cable with RJ45 connectors
RCA cables
speaker wire with four-pin Phoenix connectors
NetStreams AP300 Audio Port.
How it Works
When voltage is sensed from the speaker wires of the output on the receiver, a relay is
switched over. This routes output to the speakers.