Connectors, Tl380 installation, Tl430/tl700 installation – ClearOne DigiLinX User Manual
Page 55: Connectors -4, Tl380 installation -4, Tl430/tl700 installation -4
DigiLinX Installation and Design Guide
6-4
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
External dimensions:
7 7/8” high x 4 15/16” wide x 1 9/16” deep (200mm x 146mm x 39.7mm)
Weight: 1 lb., 6 oz. (0.612 Kg)
NetPower: 1
Faceplates: white, ivory, black, almond.
Connectors
The following connectors are on a TouchLinX:
Ethernet: two (TL430 and TL700) or four (TL380) RJ45 ports.
power input: four-pin Phoenix connector (included)
power output: four-pin Phoenix connector (included).
TL380 Installation
To install a TouchLinX TL 380 into a wall, complete the following steps:
1.
Install a double-gang backless box into a wall. (TL380 only)
2.
Make all connections to the device.
3.
Mount the device in the box.
4.
Turn power on to the device.
5.
Refer to the DigiLinX Dealer Setup Manual located on the Dealer Documents page
on the NetStreams web site to configure the device.
NOTE:
A white, screwless faceplate is included. Ivory, Almond, and Black color kits are sold
separately.
6.
Snap the screwless faceplate onto the cover.
TL430/TL700 Installation
To install a TouchLinX TL430 or TL700, complete the following steps.
1.
Use the included template to mark the wall and cut the hole for the TouchLinX.
NOTE:
The tolerance between the edge of the template and the edge of the TouchLinX is
about 1cm. Measure twice, cut once.
2.
Make all connections to the device.
3.
Insert the TouchLinX into the hole.