Connectors, Installation, Installing a medialinx mla9101-cs into a rack – ClearOne DigiLinX User Manual
Page 43: Connectors -4 installation -4, Installing a medialinx mla9101-cs into a rack -4
DigiLinX Installation and Design Guide
5-4
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
High capacity Digital Signal Processor for individual sources
Power management sensor for video, LED, or level sensing of audio sources for
audio playback
Mounting holes for easy screw mounting in rack for optional rack mount shelf
(sold separately) allows up to 2 MediaLinX to be mounted side by side
Integrated IR receiver for IR learning
LEDs for signal detection, power detection, and activity status
3.5mm RS-232/IR for 2-way control of compatible traditional sources (cable
included) plus RS-232 via a DB9 connector.
Dimensions 9.5”high x 1.75” wide x 8.67” deep (244mm x 45mm x 220mm)
Weight 3.39 lb. (1.54 kg)
NetPower: 1.
Connectors
The MediaLinX MLA9101-CS has the following connectors:
audio inputs: two gold-plated RCA jacks and one coaxial digital connector
audio outputs (pass-through): two gold-plated RCA jacks and one coaxial digital
connector
Ethernet RJ45 connectors. (cable not included)
3-Position Phoenix Connector for Balanced Audio Input
power: two-pin Phoenix connector (included)
RS-232 (DB-9) for serial input
video sensor I/O: two composite video connectors (output is pass-through)
RS-232/IR output: one 3.5mm jack.
Installation
The MediaLinX MLA9101-CS can be rack mounted or placed anywhere that a
network connection is available. The MLA9101-CS uses the included rack mount ears
for rack mounting.
Installing a MediaLinX MLA9101-CS into a Rack
The MediaLinX MLA101 can be installed into a rack location. To perform this
installation, you need:
a MediaLinX MLA9101-CS
Rack mount ears (included)
To install a MediaLinX MLA9101-CS into a rack, complete the following steps:
Screw the rack mount ears into MediaLinX, then attached the completed unit into the
rack with the screws.