ClearOne DigiLinX User Manual
Page 31
DigiLinX Installation and Design Guide
3-4
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
To pre-wire for IP-Based video, complete the following steps:
1.
Install a four-port flush mounted wall plate (with CAT5e and RG6 connections) at
the video location.
NOTE:
If you are installing a home theater system, also install a four-port flush mounted wall
plate (with CAT5e and RG6 connections) near the theater equipment.
2.
From the head end, run the structured cable to the four-port flush mounted wall
plate.
3.
From the head end, run a 16/4 cable for power.
4.
Terminate using 568A terminations on the CAT5e cables.
5.
Terminate F type connections on the RG6 cables.
NOTE:
None of the runs should exceed 328 feet maximum cable length.