ClearOne DigiLinX User Manual
Page 111
DigiLinX Installation and Design Guide
15-4
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
To configure for home theater, complete the following steps:
1.
Connect each of the sources to the theater receiver as needed (four are shown in
Figure 15-2).
2.
Using an RCA cable, connect the receiver sub out to the line level switching device
(in normally open mode).
3.
Using an RCA cable, connect the line level switching device (in normally closed
mode) to the AP300 (out left and right).
4.
Using a CAT5 cable, connect the EIM port of the AP300 to the SpeakerLinX.
5.
Using an RCA cable, connect the line level switching device to the sub woofer.
6.
Using speaker wire, connect the receiver to each of three speakers (left, center, and
right).
7.
Using speaker wire, connect the receiver to the speaker switching device (in
normally open mode).
8.
Using speaker wire, connect the speaker switching device to the two rear surround
sound speakers (out).
9.
Using speaker wire, connect the speaker switching device to the speaker
connection on the SpeakerLinX (in normally closed mode).