Installing a free standing medialinx mla4000, Medialinx a/v mlav300, Specifications – ClearOne DigiLinX User Manual
Page 46: Installing a free standing medialinx mla4000 -7, Medialinx a/v mlav300 -7, Specifications -7
MediaLinX
5-7
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Installing a Free Standing MediaLinX MLA4000
The MediaLinX MLA4000 can be installed in a free standing environment. Complete
the following steps:
For a MediaLinX:
1.
Connect all legacy sources.
2.
Connect Ethernet.
3.
Connect power.
For a ControLinX:
4.
Configure the third-party system using the manufacturer’s instructions.
5.
Connect the IR emitter or RS-232 connector to the third party device.
6.
Connect a 16/2 cable from the power port of the ControLinX to a PowerLinX.
7.
Connect a CAT5 Ethernet cable from the ControLinX to a SwitchLinX.
MediaLinX A/V MLAV300
Figure 5-4 shows the rear panel of the MediaLinX A/V 300 rear panel. The input
connectors are located on the bottom. The pass-through connectors are located at the
top.
Figure 5-4
MediaLinX A/V 300 rear panel
NOTE:
The MLAV300 does not ship with a power supply. We recommend connecting the
power to a PowerLinX PL600 or PL140.
Specifications
Distribute uncompressed HD Video and surround sound over a TCP/IP network
IR/RS232 In/
Out
Analog
Audio
S/PDIF
Sense
S-Video
Component
Contact
Closures
VGA Ethernet Power