ClearOne DigiLinX - Manual (Page 11)

DigiLinX Installation and Design Guide
1-4
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
 512 MB of RAM
 1.2GHz processor (1.6GHz processor recommended).
Prior to Installation
The following are important to know before installing the DigiLinX system:
 Cable Connections - Ensure all cables are connected and terminated properly.
 Firewall - Temporarily disable all firewalls that may be running on your PC.
 IP Addressing for third-party hardware - Set the IP address for IP cameras and
media servers prior to configuring them in DigiLinX. Consult the product user’s
guide for information on setting the IP address.
NOTE: If you have difficulty establishing a network connection after completing these
steps, call NetStreams Technical Support at +1(866)353-3496.
Additional Hardware
There are several third-party devices that can work with the DigiLinX system. Each
should be installed and set up using the manufacturer’s software before configuration
with the DigiLinX Dealer Setup program. These additional products include but are
not limited to:
 Panasonic
®
IP Cameras
 Polk
®
IP Speakers
 media servers - Audio ReQuest
®
(all models), Imerge Soundserver MKII
®
, Imerge
S3000
®
, and Escient Fireball
®
 Lutron
®
RadioRA
®
 Lutron HomeWorks
®
 Aprilaire
®
HVAC system
 Sonance
®
IPort
™
 GE
®
Concord
™
 Vantage
™
 devices connected to the system through use of NetStreams’ General Purpose
Driver.
NOTE: RS-232 connections for General Purpose devices are one-way only. With the
release of DigiLinX Dealer Setup v. 1.50, installers with programming
experience will be able to custom-program RS-232 drivers. See the Writing