Connectors, Installation, Installing a medialinx101 into a rack – ClearOne DigiLinX User Manual
Page 41: Connectors -2 installation -2, Installing a medialinx101 into a rack -2
DigiLinX Installation and Design Guide
5-2
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
RCA and S/PDIF inputs and outputs for connection flexibility and pass-through of
analog and digital stereo audio
High capacity Digital Signal Processor for individual sources
Power management sensor for video, LED, or level sensing of audio sources for
audio playback
Mounting holes for easy screw mounting in rack for optional rack mount shelf
(sold separately) allows up to 2 MediaLinX to be mounted side by side
Integrated IR receiver for IR learning
LEDs for signal detection, power detection, and activity status
3.5mm RS-232/IR for 2-way control of compatible traditional sources (cable
included)
Dimensions 8.25”high x 3.41” wide x 2” deep (210mm x 86.5mm x 50mm)
Weight 1 lb. (0.6 kg)
NetPower: 1.
Connectors
The MediaLinX MLA101 has the following connectors:
audio inputs: two gold-plated RCA jacks and one coaxial digital connector
audio outputs (pass-through): two gold-plated RCA jacks and one coaxial digital
connector
Ethernet RJ45 connectors. If CAT5 cable is being used, a CAT5 connector is
needed (not included)
power: two-pin Phoenix connector (included)
video sensor I/O: two composite video connectors (output is pass-through)
RS-232/IR output: one 3.5mm jack.
Installation
The MediaLinX MLA101 can be rack mounted using the RP24/RP25 Universal Rack
Plate or it can function as a standalone device.
Installing a MediaLinX101 into a Rack
The MediaLinX MLA101 can be installed into a rack location. To perform this
installation, you need:
a MediaLinX MLA101
an RP25 rack mount plate (sold separately).
To install a MediaLinX MLA101 into a rack, complete the following steps:
1.
Screw the MediaLinX MLA101 (up to two) onto the rack mount plate (see
Figure 5-2).