Step 1: installing and connecting hardware, Connecting digilinx devices, Connecting a pc/mac/windows media center – ClearOne DigiLinX User Manual
Page 106: Connecting the nas drive, Connecting usb devices, Connecting power, Step 1: installing and connecting hardware -3
Streaming Music Manager
14-3
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Step 1: Installing and Connecting Hardware
Figure 14-2 illustrates how to install and connect the hardware.
Connecting DigiLinX Devices
1.
Turn power off to all devices.
2.
Connect the speakers to the SpeakerLinX.
3.
Using CAT5 cable or using 16/4 or 14/4 speaker wire, connect the SpeakerLinX to
the TouchLinX.
4.
Using 16/4 or 14/4 speaker wire, connect the TouchLinX to the PowerLinX.
5.
Using CAT5 cable connect the TouchLinX to the SwitchLinX.
6.
Using CAT5 cable connect the SMM100 to the SwitchLinX.
Connecting a PC/Mac/Windows Media Center
Using CAT5 cable connect the computer to the switch/router on the home network.
Connecting the NAS Drive
Configure the NAS drive using the manufacturer’s software. Use CAT5 cable to
connect the NAS drive to the PC’s switch/router.
IMPORTANT!
Ensure that you configure your computer and NAS drive with an IP
address that matches the IP address range used by the DigiLinX and home network.
Refer to Chapter 15 of the DigiLinX Dealer Setup Manual on the Dealer Documents
page of the NetStreams web site.
Connecting USB Devices
Connect any USB storage device into one of the USB ports on the SMM100.
NOTE:
If you are rack mounting and want to insert a USB device into the SMM100, you may
install a USB extension so that the port is accessible at the front of the unit after mounting.
Examples of USB storage devices include the Apple™ iPod, Creative Nomad, Dell™
DJ, USB Flash-based storage drives, and USB-connected hard drives.
Connecting Power
Connect power to the PC, NAS drive, SMM100, and PowerLinX. Turn on the power to
all devices.