Specifications, Connectors, Installation – ClearOne DigiLinX User Manual
Page 59: Installing in a wall, Specifications -2, Connectors -2, Installation -2, Installing in a wall -2
DigiLinX Installation and Design Guide
7-2
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
IMPORTANT!
Both the KL100/KL101 and KL200/KL201ship with an Expansion
Interface Module (EIM) splitter. This EIM splitter must be used when installing both a
KeyLinX and an Audio Port or MU290 power amplifier.
KeyLinX are perfect for smaller rooms that do not require a touchscreen. The
KeyLinX models feature up to six presets for each one of the four audio sources. These
presets are programmed from the DigiLinX Dealer Setup Program and are accessible
by pressing and holding the corresponding key on the KeyLinX for two seconds.
Specifications
Two RJ-45 connectors (EIM)
Fits in standard single-gang box
Green LEDs for volume status
IR Receiver
Built-in microphone
Ten laser-etched hard key buttons
Faceplate: white, almond, ivory, or black
In-wall dimensions: 1 3/4” wide x 2 13/16” high x 1 1/4” deep (45mm x 71mm x
32mm)
External dimensions: 2 3/4” wide x 4 5/8” high x 1 1/2” deep (69mm x 117mm x
38mm)
Weight: 4.9 oz. (139 grams)
NetPower: 1.
Connectors
The KeyLinX has two RJ45 connectors.
Installation
To install a KeyLinX, complete procedures in the following sections.
Installing in a Wall
To install a KeyLinX into a wall, complete the following steps:
1.
Install a single-gang backless box into a wall.
2.
Make all connections to the device.
3.
Mount the device in the box.