Installation, Medialinx a/v mlav9300-cs, Specifications – ClearOne DigiLinX User Manual
Page 48: Installation -9, Medialinx a/v mlav9300-cs -9, Specifications -9
MediaLinX
5-9
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Installation
The MediaLinX A/V is a half-rack width, 1U high device. Use a RS1U rack shelf to fit
two MediaLinX A/Vs per shelf. To fit only one MediaLinX A/V, use the blank plate
provided with the RS1U. Screws are included to screw the rack mounted device on the
rack shelf.
Depending on its use, connect S/PDIF, component, composite, VGA, or S-Video. If
you are connecting it to a PC, you would use the VGA connection. Be sure to connect
both Analog Audio and S/PDIF. Connect the Ethernet CAT5 cable to the Ethernet port.
Connect the power cable to the Power port.
MediaLinX A/V MLAV9300-CS
Figure 5-4 shows the rear panel of the MediaLinX A/V 300 rear panel. The input
connectors are located on the bottom. The pass-through connectors are located at the
top.
Figure 5-5
MediaLinX A/V 9300-CS rear panel
NOTE:
The MLAV9300-CS does not ship with a power supply. We recommend connecting
the power to a PowerLinX PL600 or PL140.
Specifications
Distribute uncompressed or MotionXT compressed HD Video and surround sound
over a TCP/IP network
Real-time conversion of one component, composite, S-Video or RGBHV video
signal, and one stereo analog and digital S/PDIF audio signal from a video source
into TCP/IP uncompressed audio/video streams
480i format conversion across: Composite to S-Video, S-Video to Component or
vice versa
Power
Ethernet
RGBHV + Component
Sense
Digital Audio Input
Analog Audio In
Relay
Balanced Audio In
RS-232