Rockwell Automation 2098 CompactLogix Indexing Motion Accelerator Toolkit Quick Start - Manual (Page 48)

48 Publication IASIMP-QS011B-EN-P — January 2009
Chapter 5 Motion Logix Integration
2. When the software opens,
click the Online button to
go online to your network.
3. Browse to your controller.
4. Under Backplane, expand the Local 1769 Bus
Adapter and the 1769 Bus.
5. Under the 1769-SDN, highlight Port2.
6. Click OK to go online.
7. Click OK again to begin searching for all available network nodes.
8. Click Cancel after all available nodes have been identified. You don’t have to wait for it to
search for nodes you don’t have in your system.
9. Your network should look similar to this.
This reflects a single-axis system. Refer to
the information in Additional Information
for Single and Multi-Axis Systems on
page 50 for using additional axes and for
more detailed information.
10. Right-click Ultra3000 and select Upload
from Device to upload existing parameters
for the Ultra3000 servo drive.
Since there are over 1000 parameters in the
drive, this takes a while.
11. Repeat step 10 to upload parameters for all
additional Ultra3000 drives.