Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual User Manual

Rockwell Automation Equipment

Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual User Manual | 232 pages

Table of contents

Document Outline

GV3000/SE AC General Purpose (V/Hz) and Vector Duty Drive Software Start-Up and Reference Manual D2-3359-6
Important User Information
Document Update
Summary of Changes
Table of Contents
1 - Starting Up the Drive for Volts/Hertz Regulation
- Preparing for Start Up (Volts/Hertz)
- Start-Up Procedure (Volts/Hertz)
2 - Starting Up the Drive for Vector Regulation
- Preparing for Start Up (Vector)
- Start-Up Procedure (Vector)
3 - Using the Keypad/Display to Program, Monitor, and Control the Drive
- Monitor Mode
- Program Mode
- Drive Control
- The Display
- The Keypad
- Drive Status LEDs
- Monitor Mode LEDs
4 - Programming Reference
- Parameter Menus
- Parameter Types
- Displaying or Changing Parameter Values
- Ensuring Program Security
- First Menu Parameters
- Second Menu Parameters
5 - Troubleshooting the Drive Using Error Codes
- Identifying Alarm Codes and Recovering
- Identifying Fault Codes and Recovering
- Accessing, Reading, and Clearing the Faults in the Error Log
- Identifying Fatal Fault Codes and Recovering
A - Alphabetical Listing of Parameters
B - Record of User Parameter Settings
C - Power Module-Dependent Parameter Default Values
D - Compliance with Machinery Safety Standard EN 60204-1: 1992
E - Default Parameter Settings
F - Configuring the Digital Inputs When the RMI Board Is Installed in the Drive
G - Using the Terminal Strip Analog Input
- Configuring the Analog Input
- Using the Analog Input as Speed or Trim Reference
- Using the Analog Input for Vector Torque Reference (U.000 = 1)
- Using the Analog Input to Start and Stop the Drive
H - Drive Regulation Overview
INDEX
Back Cover / Publication D2-3359-6 June 2013