Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual - Manual (Page 38)

1-24 GV3000/SE AC Drive Software Reference, Version 6.06
End of V/Hz Start-Up Procedure
This is the end of the basic V/Hz start-up procedure. When the start-up values are
final, Appendix B can be used to record final settings.
To configure the remaining parameters according to the specific application, refer to
Chapter 4, Programming Reference. If you have purchased the Control and
Configuration Software (CS3000), save your configuration to a personal computer.
Refer to the CS3000 software instruction manual (D2-3348) for this procedure.
Recall that the Control Source parameter (P.000) was set to LOCL in this start-up
procedure. If you need to operate the drive from a different control source, you will
need to change the setting in parameter P.000.
Step 8.3 Press the ENTER key repeatedly to move to the VOLTS display.
This example shows the output volts at
Maximum Speed (P.004). Your actual
reading may be different.
VALUE READ:
Step 8.4 Press the ENTER key to move to the AMPS display.
This example shows the output amps at
Maximum Speed (P.004). Your actual
reading may be different.
VALUE READ:
Step 8.5 Press the ENTER key to move to the Hz display.
This example shows the Hz value
corresponding to the value set in
parameter P.004, Maximum Speed.
Your actual reading may be different.
VALUE READ:
Step 8.6 Press the STOP/RESET key. The driven motor should stop as
programmed in P.025, Stop Type.
)RUZDUG
5HYHUVH
$872
0$1
(17(5
581
-2*
PROGRAM
67$57
6723
5(6(7
63(('
92/76
$036
+]
.Z
72548(
3DVVZRUG
5811,1*
5(027(
-2*
$872
)25:$5'
5(9(56(
352*5$0
5(/,$1&(
(/(&75,&
L
)RUZDUG
5HYHUVH
$872
0$1
(17(5
581
-2*
PROGRAM
67$57
6723
5(6(7
63(('
92/76
$036
+]
.Z
72548(
3DVVZRUG
5811,1*
5(027(
-2*
$872
)25:$5'
5(9(56(
352*5$0
5(/,$1&(
(/(&75,&
)RUZDUG
5HYHUVH
$872
0$1
(17(5
581
-2*
PROGRAM
67$57
6723
5(6(7
63(('
92/76
$036
+]
.Z
72548(
3DVVZRUG
5811,1*
5(027(
-2*
$872
)25:$5'
5(9(56(
352*5$0
5(/,$1&(
(/(&75,&