Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual - Manual (Page 89)

Programming Reference 4-3
Parameter Name: the name assigned to a parameter number. The parameter
name is not displayed when programming the drive using the keypad/display. The
parameter name is only visible when using the CS3000 software or Operator
Interface Module (OIM).
Parameter Description: a description of the parameter’s function.
Parameter Range: the pre-defined parameter value limits or selections.
Default Setting: the factory default setting.
Parameter Type: identifies whether the parameter is tunable, configurable, or read
only.
Refer also to parameters: a list of associated parameters that may provide
additional or related information.
4.3 Displaying or Changing Parameter Values
Use the following procedure to display or change parameter values:
Step 1. Press the PROGRAM key until the PROGRAM LED turns on to enter
program mode.
One of the main parameter menus (P.---,
H.---, U.---, Err, etc.) will be displayed.
Step 2. Use the ▲ key or the ▼ key to move through the menus.
Note that if P.--- and Err are the only two
menu selections displayed, access to the
Second Menu parameters has been
restricted. A password must be entered into
parameter P.006 in order to access the
Second Menu parameters. Refer to section
4.6 for this procedure.
3
)RUZDUG
5HYHUVH
$872
0$1
(17(5
581
-2*
PROGRAM
67$57
6723
5(6(7
63(('
92/76
$036
+]
.Z
72548(
3DVVZRUG
5811,1*
5(027(
-2*
$872
)25:$5'
5(9(56(
352*5$0
5(/,$1&(
(/(&75,&
(
)RUZDUG
5HYHUVH
$872
0$1
(17(5
581
-2*
PROGRAM
67$57
6723
5(6(7
63(('
92/76
$036
+]
.Z
72548(
3DVVZRUG
5811,1*
5(027(
-2*
$872
)25:$5'
5(9(56(
352*5$0
5(/,$1&(
(/(&75,&