Start-up procedure (vector), Vhoi, 2 start-up procedure (vector) – Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual User Manual

Page 41

Starting Up the Drive for Vector Regulation

2-3

To Restore a Default Parameter Value after Writing over It:

If you enter the wrong value while programming parameters, you can restore the

default if you have not yet pressed the ENTER key. To do so:
1. Press the PROGRAM key.
2. Press the ENTER key. The default value of the parameter will be displayed again.

You can select it with ENTER or enter a new one and press ENTER.

To Restore All the Default Values to General (P) Parameters:

If you need to restore all the default values for General (P) parameters after

programming them, you can do so using the Restore Defaults parameter (P.050).

2.2 Start-Up Procedure (Vector)

This section describes the start-up procedure for drives set up for vector regulation.

Before using this procedure, you should have read section 2.1 for information you

need to know before working with the drive.
Step 1. Power Up the Drive

This step verifies that the drive powers up and passes the power-up diagnostics. After

the drive passes the diagnostics, the keypad/display automatically enters monitor
mode with speed displayed.

Turn power on.

The initial display will show SELF,

with all monitor mode and status

LEDs on, indicating the drive is

performing power-up diagnostics.

After diagnostics are complete (5-6

seconds), the SPEED LED is on and

the keypad/display is in monitor

mode. The displayed value is zero.

You can move through the six items

that can be accessed in monitor

mode - Speed, Volts, Amps, Hz, Kw,

and Torque - by pressing the ENTER

key.

VHOI

)RUZDUG

5HYHUVH

$872

0$1

(17(5

581

-2*

PROGRAM

67$57

6723

5(6(7

63(('
92/76
$036
+]

72548(
3DVVZRUG

5811,1*

5(027(
-2*

$872
)25:$5'
5(9(56(
352*5$0

5(/,$1&(

(/(&75,&