Xl – Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual User Manual

Page 54

2-16

GV3000/SE AC Drive Software Reference, Version 6.06

Step 6.5 Press the ▲

key to increase the value.

Important: If you are going to change the value for this parameter, see the

description in chapter 4.

The adjustment options are:

0 = Speed loop output (default setting)
1 = Terminal strip analog input
2 = Option port (network torque reference

3 = Selected speed reference

VALUE ENTERED:

Step 6.6 Press the ENTER key to save the displayed value.

After pressing ENTER, the same parameter

number is displayed. You can now go to the

next parameter.

Step 6.7 Press the ▲

key to display U.001, Encoder PPR.

This parameter selects the number of pulses

per revolution (PPR) of the encoder or

selects sensorless vector control (SVC) if an

encoder is not used.

For flux vector control (FVC), when the

self-tuning procedure (step 8) is performed,

the value of this parameter is automatically

set; however, if the encoder PPR is known, it

should be entered now.

)RUZDUG

5HYHUVH

$872

0$1

(17(5

581

-2*

PROGRAM

67$57

6723

5(6(7

63(('
92/76
$036
+]

72548(
3DVVZRUG

5811,1*

5(027(
-2*

$872
)25:$5'
5(9(56(
352*5$0

5(/,$1&(

(/(&75,&

ATTENTION: The setting of parameters U.001 (Encoder PPR), U.002

(Motor Poles), U.003 (Motor Nameplate Base Frequency), U.005 (Motor

Nameplate RPM), and U.017 (Motor Top Speed) determines the motor

maximum speed. These parameters must be set by a qualified person

who understands the significance of setting them accurately. Failure to

observe this precaution could result in bodily injury.