Rockwell Automation GV3000/SE AC Gen. Purpose and Vector Drive Software Start-Up and Ref. Manual - Manual (Page 78)

3-2 GV3000/SE AC Drive Software Reference, Version 6.06
3.1 Monitor Mode
Monitor mode is the keypad/display’s default mode during drive operation or it is
entered by pressing the PROGRAM key until the PROGRAM LED turns off. The
following output data can be displayed in monitor mode:
• Speed
• Volts
• Amps
• Hz
• Kw
• Torque (vector regulation only)
• Selected reference (speed or torque)
To select a value to monitor, press the ENTER key until the LED turns on next to the
desired display item. Pressing the ENTER key advances you through each of the
displays. (Note that all of the LEDs turn on to indicate the selected reference display.
Refer to section 3.1.1.)
3.1.1 Displaying the Selected Reference
In monitor mode, you can display the speed reference (speed or frequency) or the
torque reference the drive is using while it is running (RUNNING LED is on, JOG LED
is off). Follow these steps to display the selected reference:
Step 1. If you are not already in monitor mode, access it by pressing the PROGRAM
key until the PROGRAM LED turns off.
Step 2. Press the ENTER key repeatedly to advance through each of the monitor
mode LEDs. All of the monitor mode LEDs will then turn on at once and the
reference will be displayed. Note that the displayed speed reference value is
scaled based on P.028. The torque reference value is displayed in percent.
Figure 3.2 – Example of a Monitor Mode Display
LL
)RUZDUG
5HYHUVH
$872
0$1
(17(5
581
-2*
PROGRAM
67$57
6723
5(6(7
63(('
92/76
$036
+]
.Z
72548(
3DVVZRUG
5811,1*
5(027(
-2*
$872
)25:$5'
5(9(56(
352*5$0
5(/,$1&(
(/(&75,&
based on selected monitor mode LED.
Displays value (SPEED, VOLTS, etc.)
To enter monitor
mode, press the
PROGRAM key
until the
PROGRAM LED
turns off.
One of 6 LEDs
is on.