Rockwell Automation 9307 FactoryTalk EnergyMetrix - Manual (Page 9)

1 • Overview
9
 Create and print daily or monthly cost and billing reports by:
 Meter
 Business group
 Department
 Site
 Create energy budgets and forecasts
 Compare and contrast alternative utility rates; do ‘what-if’ for other rate structures
 Print and store all reports and charts
FactoryTalk EnergyMetrix software is a sophisticated power quality analysis tool
 Overlay waveforms to correlate phase to phase relationships
 Plot Transients, Surges, and Sags on ITI (CBEMA Curves)
 Display Harmonics. THD, K-factor, Crest Factor, and Vector Diagrams
 Generate Power Quality charts and reports
 PowerQuality data is automatically logged in FactoryTalk EnergyMetrix software and
then it clears the queue
FactoryTalk EnergyMetrix software generates alarms
 Triggered by
 System anomalies
 Power quality event
 User predefined conditions
 Workstation alarms
 E-mail alarms
FactoryTalk EnergyMetrix Software Components
This section describes the components of the software.
License Options
FactoryTalk EnergyMetrix software is a scalable, modular software application. Its
components and capabilities are determined by the licenses purchased and installed by the
user. Licenses are installed by means of FactoryTalk Activation.
The table below shows the component type and, if applicable, the number of meters
supported. There is no limit on the number of users. It is the customer's responsibility to
observe the requirements of software licenses.
The Manager license is required for use of the software, and includes 10 meters which can
be any combination of RSLinx software and 3rd-party OPC meters. Additional meter
licenses can be purchased in 10-, 50, 100- and 500- meter sets. The FTEMOPC 3rd-party
OPC option enables 3rd-party OPC connectivity to all licensed meters.