Rockwell Automation 9307 FactoryTalk EnergyMetrix - Manual (Page 294)

FactoryTalk EnergyMetrix Software
294
 Updated FactoryTalk activation manager to version 3.40 (CPR 9 SR 4).
 Internet Explorer WebControls are no longer used.
 Pareto Chart added to standard reports.
Issues Resolved in Version 1.9
 ADR wizard for ControlLogix hard-coded the COP instruction for 10 tags.
 PQ Event logging would relog last event after logger restart.
 Demand Analysis report showed 0% for percent contribution.
 MicroLogix device type was missing its icon.
 Copying a meter could result in a too-long name and cause an error.
 Auto generated reports did not show correct timestamp on web page. Reports were
generated with the correct date/time range however.
Intended Audience
This user manual is intended for developers and administrators of the FactoryTalk
EnergyMetrix software and its project configuration. We assume that you are familiar with
the following:
 Microsoft Windows-based personal computers
 Client-server systems
 Ethernet networking
 Microsoft Windows operating systems
 OLE for Process Control (OPC) communication
 Microsoft SQL Server
 Microsoft Internet Information Services
 Allen-Bradley power monitors
 Allen-Bradley programmable logic controllers (PLC)
 RSLinx Classic communication software
RSLinx Classic Software on 64-bit Server Tips
When you set up Devices such as power monitors, and PLCs, you need to access RSLinx
Classic software running on the server to configure drivers and network addresses of
devices. You access the RSLinx Classic user interface to perform tasks such as configure
drivers, monitor devices in RSWho, and set up OPC topics.
RSLinx Classic software is required to run as a Windows service. In Windows 2008
Server, when RSLinx runs as a service the user interface is not available to the user. The
user interface is only available when RSLinx runs as an application.
In Windows 2008 Server, follow these steps to access the user interface of RSLinx Classic
software.