Rockwell Automation 1797-OE8H FLEX Ex HART Analog Modules User Manual - Manual (Page 162)

Publication 1797-6.5.3 - March 2006
C-14 Additional HART Protocol Information
68 Trim analog output
gain 0 Analog output number
code — — As in command —
1 Analog output units
code
2…5 Externally measured
analog output level (F)
69 Write analog output
transfer function 0 Analog output number
code — — As in command —
1 Analog output transfer
function code
70 Read analog output
end point values 0 Analog output number
code — 0 Analog output number
code —
1 Analog output end
point units code
2…5 Analog output upper
end point value
6…9 Analog output lower
end point value
107 Write burst mode
transmitter variables
(for Command #33) 0 Transmitter variable
code for slot 0 — — As in command —
1 Transmitter variable
code for slot 1
2 Transmitter variable
code for slot 2
3 Transmitter variable
code for slot 3
108 Write burst mode
command number 0 Burst mode command
number — — As in command —
109 Burst mode control 0 Burst mode control
code (0 = exit, 1 =
enter) — — As in command —
Table C.6 Common Practice Commands
Command Data in Command Data in Reply
# Function Byte Data Type (5) Byte Data Type (5)