Rockwell Automation 1797-OE8H FLEX Ex HART Analog Modules User Manual - Manual (Page 158)

Publication 1797-6.5.3 - March 2006
C-10 Additional HART Protocol Information
43 Set (trim) PV zero — None — — None —
44 Write PV units 0 PV units code — — As in command —
45 Trim DAC zero 0…3 Measured current
(mA) — — As in command —
46 Trim DAC gain 0…3 Measured current
(mA) (F) — As in command —
47 Write transfer
function 0 Transfer function code — — As in command —
48 Read additional
device status — None — 0…5 Device-specific status (B)
6…7 Operational modes —
8…10 Analog outputs
saturated
(7)
(B)
11…13 Analog outputs
fixed. (8)
14…24 Device-specific status
49 Write PV sensor
serial number 0…2 Sensor serial number
number — — As in command —
50 Read dynamic
variable
assignments — None — 0 PV transmitter
variable code —
1 SV transmitter
variable code
2 TV transmitter
variable code
3 FV transmitter variable
code
51 Write dynamic
variable
assignments 0 PV transmitter
variable code — — As in command —
1 SV transmitter
variable code
2 TV transmitter
variable code
3 FV transmitter variable
code
52 Set transmitter
variable zero 0 Transmitter variable
code — — As in command —
53 Write transmitter
variable units 0 Transmitter variable
code — — As in command —
1 Transmitter variable
units code
Table C.6 Common Practice Commands
Command Data in Command Data in Reply
# Function Byte Data Type (5) Byte Data Type (5)