Rockwell Automation 1797-OE8H FLEX Ex HART Analog Modules User Manual User Manual
Flex ex hart analog modules
This manual is related to the following products:
Table of contents
Document Outline
- Important User Information
- Summary of Changes
- Table of Contents
- Preface
- Chapter 1
- About the FLEX Ex HART Analog Modules
- What This Chapter Contains
- What the FLEX Ex Analog I/O Modules Do
- How FLEX Ex Analog Modules Communicate with Programmable Controllers
- Physical Features of Your Analog I/O Module
- Using Alarms on the 1797-IE8H Module
- How to Use the HART Capabilities
- HART Implementation Overview
- HART Commands
- Selecting the Correct Path
- Chapter Summary
- Chapter 2
- Understand Configurable FLEX Ex Analog Module Features
- Chapter 3
- How to Install Your FLEX Ex Analog Modules
- What This Chapter Contains
- Before You Install Your Analog Module
- Compliance to European Union Directives
- Installation in Zone 1
- Installation in Zone 22
- Electrostatic Charge
- Removal and Insertion Under Power
- Install the Module
- Wire the Terminal Base Units
- Connecting Wiring to the FLEX Ex I/O Analog Modules
- Ground the Module
- Chapter Summary
- Chapter 4
- Input, Output and Configuration Files for the Analog I/O Modules on the ControlNet Network
- Chapter 5
- Calibrate Your Module
- Chapter 6
- Apply FLEX Ex Analog I/O Modules
- Chapter 7
- Troubleshoot the FLEX Ex Analog I/O Modules
- Appendix A
- Specifications
- Appendix B
- FLEX Ex HART Module Commands
- Appendix C
- Additional HART Protocol Information
- Appendix D
- Configure the 1797-OE8H Module in RSLogix 5000 Software Over the ControlNet Network
- Appendix E
- Configure the 1797-IE8H Module in RSLogix 5000 Software Over the ControlNet Network
- Appendix F
- FLEX Ex HART Modules Network Messaging
- Index