Rockwell Automation 6185-V Industrial 18.1 Inch Flat Panel Monitor User Manual - Manual (Page 50)

50 Industrial 18.1" Flat Panel Monitor
Publication 6185-UM001B-EN-P
Cleaning
Occasionally clean the display panel and cabinet with a soft cloth
dampened (not soaked) with a mild (non-abrasive) glass cleaner. Keep
turning a fresh side of the cloth toward the screen surface to avoid
scratching it with accumulated grit.
Note: The solvent should be applied only to the cloth, and not
directly on the monitor screen.
Do not use paper products as they may scratch the surface.
To minimize the risk of abrasion, allow the screen to
stand dry.
Special care should be taken when cleaning a touchscreen or
polycarbonate shield that is installed over the screen. Abrasive and
certain chemical cleaners can easily damage the surface.
Note: For best results cleaning a monitor with the optional
antireflective tempered glass display shield, a solution of
denatured alcohol is recommended to thoroughly clean the
display.
Never use alcoholic or ammoniac cleaners to clean the
polycarbonate shield or a touchscreen.
Replacing a Line Cord
To avoid shock and fire hazards, the monitor’s power cord should be
replaced if the insulation becomes broken or if it develops a loose
internal connection.
Substitution of Components
When connecting the panel mount (6185-D) and rack mount (6185-N)
models of the RAC6185 18.1" Flat Panel Monitor, note the following
safety considerations:
ATTENTION: EXPLOSION HAZARD! – Substitution
of components may impair suitability for Class I, Div. 2
hazardous locations.
Other Maintenance
Qualified service personnel should perform all maintenance, except for
the power cord replacement described above.
Routine Maintenance
(All Models)