Rockwell Automation 6185-V Industrial 18.1 Inch Flat Panel Monitor User Manual - Manual (Page 27)

Industrial 18.1" Flat Panel Monitor 27
Publication 6185-UM001B-EN-P
To mount the monitor on the yoke:
1. If the swivel-base mounting bracket is being used, insert one of the
three knobs through the bottom hole of the yoke, placing the large
washer between the yoke and the mounting plate. Insert the knob
into the mounting bracket and tighten.
Figure 22
Mounting the Monitor in the Yoke
2. Insert the other two knobs through the sides of the yoke and place
the washers between the yoke and the monitor.
3. Tighten each knob firmly by hand, allowing enough movement to be
able to tilt the monitor as needed.
Connecting and Routing Cables to the Monitor
The figure on Page 28 shows the locations for installing the cables to
provide power, video, and optional touchscreen input on your Versa unit.
Refer to the instructions provided with the arm for detailed information
about routing cables.