Rockwell Automation 6185-V Industrial 18.1 Inch Flat Panel Monitor User Manual - Manual (Page 31)

Industrial 18.1" Flat Panel Monitor 31
Publication 6185-UM001B-EN-P
To connect AC power to the Versa mount (6185-V ) monitor:
1. Verify that power to the main switch or breaker is turned off.
2. Connect the DIN connector on the external power supply cable to the
12 VDC power input connector on the monitor. See the figure on
Page 28.
3. Connect the IEC plug end of the AC power cord to the IEC AC
power connector on the power supply.
Note: If the power supply is attached to the back of the
monitor, secure the power supply cable on the back
panel of the monitor using the wire ties and the slots in
the mounting bracket.
4. Plug the other end of the AC power cord into the main outlet.
5. Restore AC power.