Rockwell Automation 6185-V Industrial 18.1 Inch Flat Panel Monitor User Manual - Manual (Page 24)

24 Industrial 18.1" Flat Panel Monitor
Publication 6185-UM001B-EN-P
Mounting Procedures (6185-V)
The Versa mount unit can be mounted using a jointed arm or a yoke
bracket assembly. Both the arm and the yoke allow maximum
adjustment of the monitor. The optional AC power supply may be
attached to the rear of the monitor for convenience.
To mount the unit, complete the steps listed below:
1. Attach the power supply to the monitor (optional).
2. Mount the arm or yoke.
3. Mount the monitor on the arm or yoke.
To attach the AC-to-12 VDC power supply to the Versa mount unit
(optional):
1. Turn off the main switch or breaker.
2. Remove three screws from the back of the monitor with the Phillips
screwdriver.
Figure 20
Attaching the Power Supply to the Monitor
3. Position the bracket on the back of the monitor, insert the three
screws through the bracket into the monitor and tighten.
4. Orient the power supply on the bracket so the IEC AC power socket
points toward the long end of the mounting bracket and snap the
power supply in place.
5. Remove the two Phillips pan-head screws from the bottom of the
monitor.