Rockwell Automation 6185-V Industrial 18.1 Inch Flat Panel Monitor User Manual - Manual (Page 25)

Industrial 18.1" Flat Panel Monitor 25
Publication 6185-UM001B-EN-P
6. Hook one end of the retaining clip in the hole at the top of the
mounting bracket. Then align the other end of the clip over the
bottom of the monitor, insert a screw through the clip and into the
monitor, and tighten.
7. Repeat step 6 for the second retaining clip.
For information on connecting power to the unit, refer to Page 28.
To mount the monitor (benchtop or wall arm mount):
The Versa mount arm can be bolt mounted directly on a bench or a wall,
or you can mount it on a table using the edge clamp provided. For
detailed instructions on arm mounting or assembly, refer to the
documentation provided with the arm.
1. Mark the location for mounting the arm and drill the mounting holes.
Refer to the figures on Pages 21 and 22.
Note: The horizontal arm-mount unit may also be mounted on
a bench using the edge clamp provided.
2. Insert four screws through the arm brackets and secure it to the
bench or wall. Tighten the screws.
3. Adjust the pivot controls on the arm. Refer to the arm
documentation.