Rockwell Automation 6185-V Industrial 18.1 Inch Flat Panel Monitor User Manual - Manual (Page 10)

10 Industrial 18.1" Flat Panel Monitor
Publication 6185-UM001B-EN-P
Panel Mounting Guidelines (6185-D)
Observe the following precautions before installing the unit in a panel:
• Confirm that there is adequate space behind the panel. Remember to
allow extra space (0.5 in. or 12.7 mm behind and on each side) for air
circulation. A cabinet with a minimum depth of 5.12 in. (130 mm) is
sufficient.
• Take precautions so that metal cuttings do not enter any components
that are already installed in the panel.
• Supporting panels should be at least 14 gauge to ensure proper
sealing against water and dust and to provide proper support. The
mounting hardware supplied accommodates panels up to 0.25 in.
(6.35 mm) thick.
Note: Supporting panels must be cut and drilled to
specifications prior to installation.
ATTENTION: Failure to follow these warnings may
result in personal injury or damage to the panel
components.
Panel Mount Dimensions (6185-D)
This section shows the dimensions of the panel mount unit. Use this
information to ensure you have adequate space to install the unit and
route cables. Units are in mm [inches].
Figure 3
Panel Mount Dimensions (Front View)