Rockwell Automation 6185-V Industrial 18.1 Inch Flat Panel Monitor User Manual - Manual (Page 45)

Industrial 18.1" Flat Panel Monitor 45
Publication 6185-UM001B-EN-P
Adjusting Settings
Use this procedure to adjust the monitor settings for a specific resolution
and refresh rate. Once you have adjusted the monitor, the monitor
settings will automatically be saved. If you need to run the monitor at a
different resolution or refresh rate, you must adjust the settings again.
Then you can toggle back and forth between these settings as needed.
The 6185 Flat Panel Monitor will save up to 16 settings for your video
screen.
Note: The location and labeling of the control keys for the panel
mount and rack mount units (6185-D/6185-N) are different
than those for the Versa mount unit (6185-V). For ease of
reference, these instructions are written with the rack mount
and panel mount keys first and the Versa mount keys in
parentheses.
For graphics displaying the location and operation of the
controls on the monitor, see Page 36.
Important: The on-screen menu closes automatically approximately ten
seconds after you stop pressing controls. The monitor
automatically saves any changes you have made to the
settings when it closes.
Step 1 - Start the Adjustment Utility
1. Insert the diskette provided with the monitor in the floppy drive of
the host computer.
Note: The adjustment utility is designed for 32-bit operating
systems only (Windows 95/98/2000 or
Windows NT 4.0 or greater).
2. Start the Flat Panel Monitor Adjustment utility using the instructions
on the diskette label.
The utility displays an image on the screen to assist you in adjusting
the monitor settings.
Note: The utility may take several seconds to display the
screen image.