SATEC PM174 Manual User Manual
Page 92
Chapter 4 PAS Application Configuring
Recorders
92
Series PM174 Powermeters
2. Select a file type for your file.
3. Select the number of parameters you
want to be recorded in the file records.
4. Select the maximum number of records
you want to be recorded in the file.
5. Click OK, and then send your new
setup to the meter, or save to the
device database.
6. Highlight the data log file row with the
left mouse button, and then click on the
“Setup Recorder” button, or click on the
“Data Recorder” tab and select the log
number corresponding to your file.
7. Configure the list of parameters to be recorded in your
data log file. You are not allowed to select more
parameters than you defined when configuring your file.
Refer to Appendix D for a list of available parameters.
For your convenience, PAS will follow your selection and
help you to configure a series of the neighboring
parameters: when you open the “Group” box for the next
parameter, PAS highlights the same group as in your
previous selection; if you select this group again, PAS will