SATEC PM174 Manual - Manual (Page 66)

Chapter 4 PAS Application Configuring Communications in your
66 Series PM174 Powermeters
data. PAS automatically truncates your range if you
specify more data than the exchange can accommodate.
To indicate the end of the address range list, put a zero
start point ID in the range following the last range you
specified.
6. Click on Send to download your new setup to the meter.
The device will reject your setup if you specified an
inexistent start point ID for one of the address ranges. If
you specified more points in a range than the device can
provide, it truncates the range to the maximum number of
points available.
You can also temporarily put a configured exchange into the
pending (disabled) state, and then resume (enable) it
whenever needed.
NOTE
When you change the consumer IP address through the
Ethernet, the device port restarts and communications will be
temporarily lost, so you may need to wait until PAS restores a
connection with your device.