SATEC PM174 Manual - Manual (Page 123)

Chapter 4 PAS
Application Software Viewing Recorded Files
Series PM174 Powermeters 123
Viewing a Spectrum Chart
Click on the
button to view a spectrum chart. To change a
channel, click on the window with the right mouse button,
select “Channels...”, check the channel you want displayed,
and then click OK.
A spectrum is calculated over four cycles of the waveform
beginning from the point where the left marker line is located.
If there are more than one waveform views open, PAS gives
the priority to the overlapped waveform view.