Lenze E94AYCET - Manual (Page 93)

Lenze · E94AYCET communication module (EtherCAT®) · Communication Manual · DMS 9.0 EN · 02/2014 · TD17
93
12 Error messages
12.2 Possible causes and remedies
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
EtherCAT: Error: Lenze setting loaded [0x00c86420]
EtherCAT: Quit 'Operational' state [0x00c88131]
EtherCAT: Sync loss detected with standard device [0x00c88132]
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Access via standard device to parameter set in the
memory module was not successful.
Repeat download of the application (including module).
Response (Lenze setting printed in bold) Setting: C13880/1 / C14880/1 ( Configurable response)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The EtherCAT data exchange was stopped in the
"Operational" state.
See also chapter " Interruption of EtherCAT
communication " ( 81) .
• Check cables and terminals.
• The master has to reset the node to the "Operational"
status. (If required, check a pending emergency
message first).
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
• The cycle time settings are faulty.
• The task time setting of a linked PLC program is faulty.
• EtherCAT master / DC master settings are incorrect.
• The sync source setting is faulty.
• Check the cycle times.
• Check the task time of a linked PLC program.
• Check the EtherCAT master / DC master settings.
• Check the settings of the standard device in C01120
(selection of the sync source).