Lenze E94AYCET - Manual (Page 128)

13 Parameter reference
13.3 Parameters of the communication module for slot MXI2
128
Lenze · E94AYCET communication module (EtherCAT®) · Communication Manual · DMS 9.0 EN · 02/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C14881
C14882
C14883
C14884
Parameter | Name:
C14881 | Response time when exiting 'Operational'
Data type: UNSIGNED_16
Index: 9694 = 0x25DE
If the "Operational" state is exited, the response parameterised with C14880 occurs after the time set here has
elapsed.
A change in monitoring is effective immediately.
Setting range
(min. value | unit | max. value) Lenze setting
0 ms 65535 0 ms
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C14882 | Display of PDO watchdog time
Data type: UNSIGNED_32
Index: 9693 = 0x25DD
Available from software version 03.00!
Display of the PDO watchdog monitoring time defined in the master.
During initialisation of the EtherCAT communication, the watchdog monitoring time is transmitted to the slave.
Display area
(min. value | unit | max. value)
0 μs 4294967295
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C14883 | DC active
Data type: UNSIGNED_8
Index: 9692 = 0x25DC
The code displays if the DC synchronisation has been activated for the communication module.
 Synchronisation with "Distributed Clocks" (DC) ( 35)
Selection list (read only) Info
0 DC unused
1 DC for synchronisation
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C14884 | Base device synchronisation status
Data type: UNSIGNED_8
Index: 9691 = 0x25DB
Available from software version 03.00!
The code displays whether the drive is DC-synchronised.
 Synchronisation with "Distributed Clocks" (DC) ( 35)
Selection list (read only) Info
0 Not synchronised
1 Synchronised
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT