Lenze 8400 BaseLine Manual - Manual (Page 92)

Commissioning
Messages
7

92 EDS84ABD302 EN 4.0
7.6 Messages
The current status of the controller can be checked via:
ƒ six LEDs in different colours ( 83)
ƒ messages as follows:
Message Status Meaning
PASS Password input
CAL blinking Identification is in progress.
CAL / StoP alternatively blinking Identification is ready to start. Operation is not enabled yet.
CAL / Err alternatively blinking Identification is not ready to start. Either C00088, or C00089, or
C00090 is 0.
bF blinking Identification error. Drive ID stored in EPM does not match the drive
ID stored in the controller.
CL constant Current limit set by C00022 is reached
FCL constant Fast current limit value (higher than value of C00022) is reached
FSt constant Flying restart function is in progress
dEC constant Deceleration is temporarily suspended because of higher bus
voltage
br flashes during the hold
time of the DC brake
DC brake is in progress