Lenze 8400 BaseLine Manual - Manual (Page 91)

Commissioning
Test commissioning
Test commissioning with terminal control
7

91 EDS84ABD302 EN 4.0
4. Enable controller:
Set terminal X4/RFR to HIGH-Potential (reference: X4/GND).
5. Vary the motor speed or the motor velocity with the potentiometer or by defining
different fixed setpoints:
DI2 DI1 Motor speed
0 0 Setpoint by potentiometer
0 1 40 % of C00011 (reference speed)
1 0 60 % of C00011 (reference speed)
1 1 80 % of C00011 (reference speed)
Internal Keypad Code Subcode Motor speed
-2-
_ `
C...
C051 xxxx
C00051 - Observe
z the actual speed value:
C00051
z appearing messages  92
6. Save the settings with mains failure protection by entering the value ”1” in code
C002, subcode 7.