13 get transm.err.counters (get_tec_x), 14 read fault detector (read_fault_detector), Get transm.err.counters (get_tec_x) – EUCHNER AS-i 3.0 Command Interface User Manual
Page 41: Read fault detector (read_fault_detector)
AS-i 3.0 Command Interface
Commands of the Command Interface
Subject to reasonable modifications due to technical advances
Id.-No.: 102875 Issue date - 3.12.2007
EUCHNER GmbH + Co. KG
Kohlhammerstraße 16, D-70771 Leinfelden-Echterdingen
Tel. +49/711/7597-0, Fax +49/711/753316
41
4.4.13
Get transm.err.counters (GET_TEC_X)
Beginning with a definite slave address, the counts of the n error counters are be-
ing read out with this call.
With every reading out the counts, the error counters will be restarted.
The counts are being read out via the corresponding host interface and will be de-
leted with every read access. The counter´s value is limited to 254. 255 will cause
a counter overflow.
The counts could be independent of the counters, which are displayed in the dis-
play of the gateway.
4.4.14
Read fault detector (READ_FAULT_DETECTOR)
With this call all informations of the AS-i detector are read out. In the first byte are
stored the values transferred in the moment, in the second all values since the last
deleting. By it is possible to recognize immediate, no more existing before mes-
sages also. The second byte is deleted by reading.
Request
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
1
66
16
2
T
–
circuit
3
1. slave address
4
number of counters
Response
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
1
66
16
2
T
result
3
counter 1
…
…
n
counter n - 2
!!!
The command READ_FAULT_DETECTOR is valid only for the use with mas-
ters which support this function.
Please see the user manual of the master for further information.
Request
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
1
10
16
2
T
–
circuit