EUCHNER AS-i 3.0 Command Interface - Manual (Page 11)

AS-i 3.0 Command Interface List of all Commands
Subject to reasonable modifications due to technical advances Id.-No.: 102875 Issue date - 3.12.2007 EUCHNER GmbH + Co. KG
Kohlhammerstraße 16, D-70771 Leinfelden-Echterdingen Tel. +49/711/7597-0, Fax +49/711/753316
11
page 71
Integrated AS-i sensors:
Availability
04
16
sensors with deleted D2 bit 3 6
page 72 language-select 0E
16
read display language 3 3
page 73
replacement of safety
slaves input data
0F
16
read safety input slave "interpreta-
tion data"
3 4
page 74 list of safety slaves 10
16 read addresses of safety slaves 3 6
! page 58 EXT_DIAG 4 71
16 ExtDiag generation 6 2
! page 59 RD_EXT_DIAG 5 7B
16 read ExtDiag Settings 2 7
page 60 INVERTER 7C
16 configure inverter slaves 12 4
page 60 MB_OP_CTRL_WR_FLAGS 85
16 write flags
≥5
2
page 61 MB_OP_CTRL_RD_FLAGS 86
16
read flags 4 ≥3
page 61 RD_MFK_PARAM 59
16 read SEW MFK21 parameter 6 ≥3
1. The command READ_FAULT_DETECTOR is valid only for the use with masters which support this function. Please refer to the user manual of
the master for further information.
2. The command READ_DUPLICATE_ADDR is valid only for the use with masters which support this function. Please refer to the user manual of
the master for further information.
3. The command REWRITE_DPRAM is valid only for the use with AS-i 3.0 Module OEM Master
4. The command EXT_DIAG is valid only for the use with AS-i 3.0 PROFIBUS Gateways
5. The command RD_EXT_DIAG is valid only for the use with AS-i 3.0 PROFIBUS Gateways
Values for command
see page Command Value Meaning
Req
Len Res
Len