General functions, Master & black out function, Clear – ETC SmartFade ML v3.0.1 User Manual
Page 90: Bump master, Clear bump master, See “bump, N o t e
82
SmartFade ML v3.0.1 User Manual
General Functions
Master & Black Out function
To get light output (at all), the Master needs to be at full, and the Black Out button off.
The Master fader proportionally limits all intensity outputs, while parameters for devices are
left untouched. As soon as the Master is faded under 100% the Blackout button will blink.
The Blackout button instantly sends all intensity outputs to zero. As soon as it is activated
the button will light up. Device parameters are not affected by these two functions.
N o t e :
The Independent channels patched to IND 1 and IND 2 are not affected by the Master
fader or Black Out button unless they are set to “GM” in the Independent Settings.
“Set up Independents” on page 22.
Light output from the intensity faders is also affected by the NEXT button.
Clear
Clear is a very useful button that will bring you back to a “clean” state of the console with
no output. Pressing CLEAR will NEVER erase content - it only brings the fader intensities
to zero. You can press CLEAR to abort any recording function if it is blinking.
• Set all dimmer and device intensity faders to zero . . . = 2 presses
• Set all memory faders to zero (blackout) . . . . . . . . . . = 3 presses
• Set sequence/Stack faders to zero (blackout) . . . . . . = 4 presses
• Deselect all currently selected devices . . . . . . . . . . . = 5 presses
CLEAR is also used in combination with other keys. For example
Bump Master
The Bump Master sets the level to which bump buttons will flash. See Bump Button
functionality for each type of fader mode.
Action
Console
Feedback
Clear A intensities
and
All INT A intensities are cleared.
Clear B intensities
and
All INT B intensities are cleared.
Clear Device Intensities
and
All Device intensities are cleared.
Clear Effects
and
All Effects are cleared.
Clear Stack
and
The Stack is cleared and set to zero.
Clear Fader level
and
...
The fader is set to zero.
BLACK
OUT
CLEAR
INT
A
CLEAR
INT
B
CLEAR
DEV
INTE
CLEAR
EFFECT
CLEAR
STACK
CLEAR
1
24