Special - color mix cmy, rgb & ragb, Edit a personality blind, N o t e – ETC SmartFade ML v3.0.1 User Manual

Page 42

SmartFade ML v3.0.1 User Manual

Special - Color Mix CMY, RGB & RAGB

Since SmartFade ML simplifies color mixing into Hue and Saturation - and there can be

parameters such as CMY, RGB or RAGB, it is important that you assign them in a specific

order.

Step 1:

Choose between CMY, RGB or RAGB by pressing MORE.

Step 2:

Move the fader corresponding to Cyan and press HUE.

Step 3:

Move the fader corresponding to Magenta and press HUE again.

Step 4:

Move the fader corresponding to Yellow and press HUE again.

N o t e :

It is possible to toggle CMY, RGB, RAGB for a selected OFFSET by pressing HUE.

Edit a Personality Blind

Editing blind is a way of creating a personality in a way similar to most editors, by selecting

the offset and choosing a parameter. It is not as direct and fast as using the faders, but may

be more comfortable for some operators, especially if there is no device connected.

Step 1:

Open the personality editor as described prior to this.

Step 2:

Select a channel offset with encoder 1.

Step 3:

Press a bump on the PARAM 1 or PARAM 2 pages to assign the parameter and

its HOME position value, which is taken from the position of the parameter fader

- use encoder 2 to change it. The assigned parameter is displayed in the right

display.

Step 4:

Select the next channel offset with encoder 1, and repeat the procedure until

done.

N o t e :

Pan/Tilt and color mixing have a special patching procedure described in the examples

below.

Step 5:

When you are finished editing the personality, exit the menu system with the <

key.

Step 6:

Now go to the regular Patch Device > Patch Wizard menu. The user personality

is the first in the list before the in-built personalities starting with the letter A.

Remember that once it is patched it can no longer be edited. To change the

personality edit it as described above and re-patch.