Record a sequence – ETC SmartFade ML v3.0.1 User Manual

Page 67

Program

Record a Sequence

Test sequence

Press CLEAR four times to clear all intensities. Select MEMS mode and move the fader for

the recorded sequence up. The sequence you recorded should appear on stage. The light

in the bump button of the fader will be dimmed in yellow to show that it has a sequence

stored. It lights up at full if the fader is above zero and contributing to the output.

Action

Console

Feedback

1. Activate record

sequence

All buttons that can record in this mode will

blink at full in yellow. If there is a memory or

sequence stored already, this button will be

dimmed (press CLEAR to exit).

2. Choose location

(change page if desired)

...

The moment the bump button is pressed, the

button will turn yellow. Now all bump buttons

can be stored as steps, and blink at full in red.

3. If desired, set the times

for this step

Wheels 1 & 2

4. Select source for this

step

...

You can select any memory or intensity

channel. Change fader page if desired.

When a bump button is pressed, that memory

or intensity will be stored as a step with the

times set in the wheels.

Repeat steps 3-4 until satisfied.

5. End recording

End recording. The console will return to the

fader mode prior to recording this sequence.

Press UNDO to undo this recording.

REC
SEQ