Record selected – ETC SmartFade ML v3.0.1 User Manual
Page 64
56
SmartFade ML v3.0.1 User Manual
Record Selected
Record Selected will only record and play back the selected devices plus all intensity
channels. You can mask Focus, Color, Beam parameters and INT A, INT B and INT
DEVICE intensity channels from being recorded.
Action
Console
Feedback
1. Activate Record
Selected
Buttons that can record in this mode will blink
at full. If there is a memory stored already,
this button is dimmed (press CLEAR to exit).
Mask any parameter type,
or single parameter, if
desirable
Any button that is pressed will be unlit and its
parameters masked from recording.
You can filter out single parameters from
recording by holding FOCUS, COLOR or
BEAM and toggling off the parameter but-
tons. The parameter type button will be dimly
lit when single parameters are filtered.
Mask any intensity group if
desirable
Any button that is pressed will be unlit and its
channels masked from recording.
2. If needed, change page
...
If needed, hold MEMS and press a bump
button 1-24 to change page.
3. Select fader
...
The moment the bump button is pressed, the
memory is stored and the console will auto-
matically return to it’s previous fader mode.
Press UNDO to undo this recording.
REC
SEL
FOCUS
COLOR
BEAM
INT
A
INT
B
DEVICE
INT
MEMS
1
24
1
24