Despatch P1400+ Temperature Controller - Manual (Page 10)

4
Once the instrument is installed in its mounting panel, it may be subsequently removed from it’s
housing, if necessary, as described in the Fitting and Removing Option Modules section.
Instruments may be mounted side-by-side in a multiple installation, but instrument to panel moisture
and dust sealing will be compromised. The cut-out width (for n instruments) is shown below.
1
/
4
- DIN Instruments:
(96n - 4) mm or (3.78n - 0.16) inches
If panel sealing must be maintained, mount each instrument into an individual cut-out with 6mm or
more clearance between the edges of the holes.
Note:
The mounting clamp tongues may engage the ratchets either on the sides or the top/bottom faces
of the Instrument housing. When installing several Instruments side-by-side in one cut-out, use
the ratchets on the top/bottom faces.