Despatch Protocol Manager with Protocol 3 and Protocol Plus User Manual
Ultraflex drying and firing furnace, Owners manual
Protocol Manager Instruction Manual
P
REFACE
Version 1
1
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
ULTRAFLEX DRYING AND FIRING
FURNACE
MODELS 1000, 3615, 3630, 3640
OWNERS MANUAL
C-204
VERSION 27
10/2008
PROTOCOL MANAGER
NETWORK UTILITY SOFTWARE
INSTRUCTION MANUAL
E-107
PN 324870
REVISION 1
3/2013
Table of contents
Document Outline
- Revision History
- Table of Contents
- Figures
- Tables
- 1. About This Manual
- Copyright © 2013 by Despatch Industries.
- Printed and bound in the United States of America.
- 2. Theory of Operation
- 3. Installation & Setup
- 3.1. System Requirements
- 3.2. Configure Controllers
- 3.2.1. Configure the Protocol 3 Controller
- 3.2.2. Configure the Protocol Plus Controller
- 3.3. Install Protocol Manager Software
- 3.4. Protocol Manager Software Setup
- 3.4.1. Startup and Login
- 3.4.2. Comm Setup Tab
- 3.4.3. Network Tab Setup
- 3.4.4. Windows Tab Setup
- 3.4.5. Passwords Tab Setup
- 3.5. Network Summary Window
- 3.6. Controller Run Time Window
- 3.7. Set Up Initial Recipe
- 3.7.1. Set Up Initial Recipe: Protocol 3
- 3.7.1.1. Configure Initial Recipe: Protocol 3
- 3.7.1.2. Save Initial Recipe: Protocol 3
- 3.7.1.3. Write a Recipe to the Protocol 3 Controller
- 3.7.1.4. Open An Existing Recipe: Protocol 3
- 3.7.1.5. Read a Recipe from the Protocol 3
- 3.7.2. Set Up Initial Recipe: Protocol Plus
- 3.7.2.1. Configure Initial Recipe (Protocol Plus)
- 3.7.2.2. Save Initial Recipe: Protocol Plus Controller
- 3.7.2.3. Write a Recipe to the Protocol Plus Controller
- 3.7.2.4. Open An Existing Recipe: Protocol Plus Controller
- 3.7.2.5. Read a Recipe from the Protocol Plus Controller
- 3.8. Datalog Functions
- 3.8.1. Configure Profile Datalog
- 3.8.2. Configure Lot Datalog
- 4. Starting the Controller
- 5. Troubleshooting
- 6. Appendices
- 6.1. Protocol Plus Communication Card Installation And Jumper Settings
- 6.1.1. Communication Card Installation
- 6.1.2. Communication Card Jumper settings.
- 6.1.3. Protocol Plus Controller Wiring Diagrams
- 6.1.4. Connecting Controllers to a Communications Host PC
- 6.1.4.1. Overview of Networking Multiple Protocol Plus Controllers